COPYMODE- This command allows you to copy an object and place it at a different point. First you select the object you want to copy and then you select the base point of the object. Then you select the point where you want to copy the object.
CIRCLERAD- This command allows you to set the radius of your circles to a certain length.
EDGEMODE-This command sets the cutting edges when you are going to trim certain objects. These edges may also extend from imaginary lines. This command is hard to explain in words but i do understand it.
OFFSETGAPTYPE- Controls how potential gaps between segments are treated when closed polylines are offset.
In this week i learned how to draw circles several different ways as well as rectangles. I learned how to use the trim command and found out that you can extend imaginary cutting edges in order to trim a line that is not actually intersecting an object.
No comments:
Post a Comment